The problem, in one picture
Stand two bricks one stud apart and try to fill the slot between them with plates standing on edge. Two go in. A third does not, and a sliver is left over.
That sliver is half a plate thick. It is the reason parts turned on their side never quite line up, and most of sideways building is about dealing with it.

What you will find here
Each lesson takes one question a builder runs into, shows the answer in a picture, and gives the short sum behind it, so you can check a build before you make it or order parts for it.


The lessons
Lesson 0 is an introduction for anyone who has only ever stacked bricks. The course is the ten lessons after it, from the grid to what the sums cannot tell you. Jump in wherever your question is.
0Studs on topWhat can stacking not do, and what is the way round it?
1The gridWhy don’t sideways parts line up?
2The LDUWhat unit do the sums use, and where does it come from?
3The half plateWhat is always left over, and where do I find it?
4Turning a studWhich part points a stud sideways, and where does my part land?
5A smooth sideways wallHow do I fill a space with no gap?
6Two rows of side studsHow do I mount one part across two side studs?
7Less than a studHow do I shift by half a stud, or by a hair?
8Studs underneathHow do I put studs on the bottom, or on both faces?
9At an angleHow do I fold, lean or slope?
10Before you orderWhat do the sums not tell me?
Tools and look-ups
InteractiveTry a number instead of reading a rule
Gap solverWhat fits a gap this wide?
ReferenceParts, geometry and sources
PartsEvery part by number, with a picture
GlossaryEvery term, with a drawing
AboutWhere the numbers come from
Where it began
このサイトは、三井淳平さん(@Jumpei_Mitsui)がXに投稿されたカードに着想を得て作りました。カードの形式と、ポッチの向きを変える組み合わせをすべて洗い出すという発想は、三井さんの投稿に基づいています。内容は独自に検証したもので、誤りがあればすべて当方の責任です。
This site was inspired by the cards Jumpei Mitsui (@Jumpei_Mitsui) posted on X. The card format and the idea of enumerating every way to turn a stud are his; the study is independent and any mistakes are mine.
この日本語はAIによる翻訳です。失礼な点がありましたらご容赦ください。